which subs
which subs
ok which will be better. i plan in getting 4 installed in my car
Audiobahn AW1506T
120oz Double Stacked Strontium Magnets
Power Handling: 1300watts R.M.S.
Frequency Response: 18Hz 500Hz
Efficiency: 96.4dB
PHAT 2" Multi-layer Foam Surround
Stamped and Balanced Aluminum Cone
2.5" 4-Layer AVS Voice Coil
Dual 4 Ohm Voice Coils
2, 4 or 8 Ohm Operation
Mounting Dimensions: Depth; 8" Hole; 13 3/4" Diameter; 15 3/8"
Multi-connect Lug Lock Terminals
KICKER S15L7
# Kicker Solo-Baric L7 S15L7 (dual 4 ohm)
# Kicker 15 Dual 4-ohm Voice Coil Subwoofer
# Titanium deposit cone
# Non-resonant aluminum basket
# Santoprene rubber surround
# Dual 4-ohm voice coils for wiring flexibility
# Frequency response 18-100 Hz
# Power range 75-1,000 watts RMS (500 watts per coil)
# Peak power handling 2,000 watts
# Sensitivity 89.3 dB SPL
# Top-mount depth 8-1/4
# Sealed box volume 1.5-6.0 cubic feet
# Ported box volume 3.0-6.0 cubic feet
Audiobahn AW1506T
120oz Double Stacked Strontium Magnets
Power Handling: 1300watts R.M.S.
Frequency Response: 18Hz 500Hz
Efficiency: 96.4dB
PHAT 2" Multi-layer Foam Surround
Stamped and Balanced Aluminum Cone
2.5" 4-Layer AVS Voice Coil
Dual 4 Ohm Voice Coils
2, 4 or 8 Ohm Operation
Mounting Dimensions: Depth; 8" Hole; 13 3/4" Diameter; 15 3/8"
Multi-connect Lug Lock Terminals
KICKER S15L7
# Kicker Solo-Baric L7 S15L7 (dual 4 ohm)
# Kicker 15 Dual 4-ohm Voice Coil Subwoofer
# Titanium deposit cone
# Non-resonant aluminum basket
# Santoprene rubber surround
# Dual 4-ohm voice coils for wiring flexibility
# Frequency response 18-100 Hz
# Power range 75-1,000 watts RMS (500 watts per coil)
# Peak power handling 2,000 watts
# Sensitivity 89.3 dB SPL
# Top-mount depth 8-1/4
# Sealed box volume 1.5-6.0 cubic feet
# Ported box volume 3.0-6.0 cubic feet
__________________
All work no play!
[/SIGPIC]
All work no play!
[/SIGPIC]
Last edited by airmanhoward; 11-13-2006 at 12:42 PM.
Kicker no question. Hope you've got about 2500w rms of power and a trunk the size of texas to hold that box though.
__________________
I got a dig bick. You this read wrong. You read that wrong too.
I got a dig bick. You this read wrong. You read that wrong too.
its going in a caprice and i plan on using an:
EARTHQUAKE PHD10000W
Designed for Extreme SPL and DB Drags!
~ 5000 Watts Maximum Power
~ 3000 Watts x 1 into 2 ohm
~ Mono block - single channel amplifier
~ Linkable with another PH10000W for 10,000 Watts
~ Damping Factor >800
~ 0.016 THD
~ Built-in variable 24dB/oct low pass-filter
~ All time low-pass operation
~ Two independent low level RCA inputs
~ Optically coupled remote gain control
~ 1-gauge power connection
~ 8-gauge speaker connection
~ 2-3/4" x 10-7/16" x 17-9/16"
EARTHQUAKE PHD10000W
Designed for Extreme SPL and DB Drags!
~ 5000 Watts Maximum Power
~ 3000 Watts x 1 into 2 ohm
~ Mono block - single channel amplifier
~ Linkable with another PH10000W for 10,000 Watts
~ Damping Factor >800
~ 0.016 THD
~ Built-in variable 24dB/oct low pass-filter
~ All time low-pass operation
~ Two independent low level RCA inputs
~ Optically coupled remote gain control
~ 1-gauge power connection
~ 8-gauge speaker connection
~ 2-3/4" x 10-7/16" x 17-9/16"
__________________
All work no play!
[/SIGPIC]
All work no play!
[/SIGPIC]
HK-4000D Mono Block Amp
RMS Power @ 14.4V
50W x 1 @ 4 Ohm
3600W x 1 @ 2 Ohm
RMS Power @ 17.0V
75W @ 4 Ohm
4000W @ 2 Ohm
2 Ohm Mono Stable
Temperature, Voltage & Output Level LCD Display
Thermal, Short & Overload Protection Circuitry
Platinum Plated Screw Type RCA Jacks
Double Sided Black Epoxy PCB Board
Platinum Plated Block Terminals
Fully Unregulated Power Supply
Stainless Steel Finish Heat sink
Quiet Fan Cooling System
Remote Gain Control
Full Mosfet Circuitry
Frequency Response: 10Hz - 350Hz
24dB Low Pass Filter: 50Hz - 350Hz
24dB Subsonic Filter: 15Hz - 50Hz
Variable 0 - 18dB Bass Boost Control at 45Hz
RCA Input Sensitivity: 0.2 - 8V
Low level Input Impedance: 22K Ohms
Damping Factor: 200 @ 4 Ohm
Dimensions (W x H x D) 12.4” x 2.71” x 25.86”
RMS Power @ 14.4V
50W x 1 @ 4 Ohm
3600W x 1 @ 2 Ohm
RMS Power @ 17.0V
75W @ 4 Ohm
4000W @ 2 Ohm
2 Ohm Mono Stable
Temperature, Voltage & Output Level LCD Display
Thermal, Short & Overload Protection Circuitry
Platinum Plated Screw Type RCA Jacks
Double Sided Black Epoxy PCB Board
Platinum Plated Block Terminals
Fully Unregulated Power Supply
Stainless Steel Finish Heat sink
Quiet Fan Cooling System
Remote Gain Control
Full Mosfet Circuitry
Frequency Response: 10Hz - 350Hz
24dB Low Pass Filter: 50Hz - 350Hz
24dB Subsonic Filter: 15Hz - 50Hz
Variable 0 - 18dB Bass Boost Control at 45Hz
RCA Input Sensitivity: 0.2 - 8V
Low level Input Impedance: 22K Ohms
Damping Factor: 200 @ 4 Ohm
Dimensions (W x H x D) 12.4” x 2.71” x 25.86”
__________________
All work no play!
[/SIGPIC]
All work no play!
[/SIGPIC]
Thread
Thread Starter
Forum
Replies
Last Post