want to trade for s13 w/sr20
want to trade for s13 w/sr20
i'm looking for a s13 w/sr20det in good running condition
here is what i have for trade
-type r turbo built motor
-new Precision t4/t67 turbo(780hp)
-new precision fmic 750hp
-NOS kit with a direct port 2 stage system(120 shot)
motor spec.
*GSR block mated with a b16a head = (type R)
*98 JDM GSR 1.8 liter motor stroked to 1.99 (basically a 2.0) w/9:1 cp
*Godzilla sleeved block with copper o rings to hold 40lbs of boost(golden eagle)
*moroso oil pan and sump pump
*Type R oil pump and piston oil squirters
*Manley Rods with arp studs and honda bearings
*fully blue printed and balance crank and under drive puller
*custom underdrive pulley
*ARIES 84.5mm pistons with total seal piston rings
*type r waterpump
*cometic heasd gasket 84.5mm
*B16a head with full port and polish and a 4 angle valve job
*Rev valve train including, alluminum valves, titanium retainers, and dual springs to hold up to 10,500 rpm
*type r cam shafts
*skunk 2 intake manifold with nos direct port plumed into the runners
*venom fuel rail
*nos 720cc saturated injectors with resitor box
*OBD1 pre programmed ecu set up for 12-15lbs of boost
*Exedy 7.5lbs flywheel
*act 6 puck cluch
* neuspeed spark plug wires
*type r timming belt
here is what i have for trade
-type r turbo built motor
-new Precision t4/t67 turbo(780hp)
-new precision fmic 750hp
-NOS kit with a direct port 2 stage system(120 shot)
motor spec.
*GSR block mated with a b16a head = (type R)
*98 JDM GSR 1.8 liter motor stroked to 1.99 (basically a 2.0) w/9:1 cp
*Godzilla sleeved block with copper o rings to hold 40lbs of boost(golden eagle)
*moroso oil pan and sump pump
*Type R oil pump and piston oil squirters
*Manley Rods with arp studs and honda bearings
*fully blue printed and balance crank and under drive puller
*custom underdrive pulley
*ARIES 84.5mm pistons with total seal piston rings
*type r waterpump
*cometic heasd gasket 84.5mm
*B16a head with full port and polish and a 4 angle valve job
*Rev valve train including, alluminum valves, titanium retainers, and dual springs to hold up to 10,500 rpm
*type r cam shafts
*skunk 2 intake manifold with nos direct port plumed into the runners
*venom fuel rail
*nos 720cc saturated injectors with resitor box
*OBD1 pre programmed ecu set up for 12-15lbs of boost
*Exedy 7.5lbs flywheel
*act 6 puck cluch
* neuspeed spark plug wires
*type r timming belt