cb7ronnie

TRADE ONLY.......TXT FOR FASTEST RESPONSE AND PICS
I have a 93 cb7 4 door Honda accord 5 speed its
the 10th anniversary so it has power Windows
sunroof and front and rear disc brakes no ac/ps
ive had the car for awhile now and just tired of
messing with it lots of potential i just want
something diff would love to find another 240sx
but am open to all trades list of what comes in/with the car call or txt 904 672 0885

full ported and polished f22a6
ported and polished h23 upper intake plenum
with spacer
Arp headstuds
Chipped jdm p30
680cc precision injectors
omni big bore throttle body
3" cold side piping
stock eclipse bov
godspeed intercooler
2.5" hot piping
Brand new ebay t3/t4 turbo
godspeed top mount manifold
custom carbon fiber catchcan
stock f23 bottem end
adjustable fuel pressure regulator
walbro 255
innovative lc1 wideband
dragon boost and oil pressure gague installed
where ac/heat controls were
F23 transmission
stage 3 act clutch
new cv axle
heat and ac controls relocated to glove box
Omni power adjustable coilovers
drilled and slotted front rotors on front yet to
install rears come with car
new front hub bearings
17" enkie
decent tires
acura legend front lip
shaved side moldings except driver fender to too
previous owner accident
shaved rear trunk lights
might be forgetting a few things

cons
as for the bad it has a crack in the windshield on
passenger sidehas normal rust around rear
quarters not bad but also not good of course
nice overall car just needs a new owner with
more time with the right trade or cash offer it will
come with the following

fresh out machine shop
f22a6 short block(head is on current setup) the
block has been hot tanked and cleaned and
bored to 86mm to fit f23 pistons it comes with
everything to assemble minus head gasket ne
water pump all the usual on an engine build
comes with tapped oil pan for turbo has balance
shaft delete the problem with this build was that
i didnt take in account that f23 pistons have
floating wrist pin and f22 have press in plus the
f22 rods are to large to fit into the f23 pistons
everythings there pistons rings bearings all it
would need is aftermarket rods