Fitment & Stance Pictures
You Can't Moderate Me.
Thread Starter
Join Date: Feb 2004
Posts: 12,541
Likes: 0
Received 0 Likes
on
0 Posts
I don't care if you drove a Pinto,There are vehicle specific forums.Use them.
__________________
R.I.P Pablo "Fathead" Garcia & Kevin "Slo_Si" Gonzalez Forever in our hearts.
R.I.P Pablo "Fathead" Garcia & Kevin "Slo_Si" Gonzalez Forever in our hearts.
┌∩┐(◕_◕)┌∩┐
Join Date: Jan 2005
Posts: 15,049
Likes: 0
Received 0 Likes
on
0 Posts
I never got around to taking pictures after i got Cusco Camber plates up front, so these pics don't show how my front setup was when i was finished, but you can see the rear hehe. Not the best wheels in the world. I think i did good tho for me being in high school at the time and doing the air-suspension setup myself, and cutting my fender lips out and a small pull. I had under 5mm of clearance in the rear with the bags empty and i could roll like that with no rubbing 
.
So yea these pics are to show rear fitment only! Disregard front positive camber haha, and i know they're shitty pics what can u expect from a 1.3 MP camera from like 2001
My wheel specs:
bBist SportMax 962 Silver [F: 18x7.5 +38] [R: 18x8.5 +35]
Dunlop SP Sport FM901 215/35/18 [All Around]
OTG 10mm Rear Spacers
and i had to run the rear spacers, without the inside rim of the wheel sits flush up against the rear torsion beam (or w/e it's called, the axle). Didn't have too much of a choice since i bought the wheels used for a good deal and had to do what i could to make them fit
I'm excited to see what i can do with me new car on coilovers tho, when the time comes hehe
.So yea these pics are to show rear fitment only! Disregard front positive camber haha, and i know they're shitty pics what can u expect from a 1.3 MP camera from like 2001
My wheel specs:
bBist SportMax 962 Silver [F: 18x7.5 +38] [R: 18x8.5 +35]
Dunlop SP Sport FM901 215/35/18 [All Around]
OTG 10mm Rear Spacers
and i had to run the rear spacers, without the inside rim of the wheel sits flush up against the rear torsion beam (or w/e it's called, the axle). Didn't have too much of a choice since i bought the wheels used for a good deal and had to do what i could to make them fit
I'm excited to see what i can do with me new car on coilovers tho, when the time comes hehe
thanks man, at the time i didn't even intend to do it all on purpose, it just kinda happened (the fitment).
i miss it though, so i'm going to be improving my fitment on my 240 eventually.
i miss it though, so i'm going to be improving my fitment on my 240 eventually.
I <3 USDM
Join Date: Mar 2006
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
FORE:sight
Join Date: Dec 2007
Posts: 2,332
Likes: 0
Received 0 Likes
on
0 Posts
Found this today while browsing the intraweb. It looks pretty fucking low to meeeeeeeeeeeeeeeeeeee
this too
this too
