^ ahh. I couldn't remember where. I was just bored on Google looking up RB builds and it just popped up.

 

so i did a little research and couldnt find shit. your using the r33 crossmember correct? how is the fitment of that compatible with the s13/14? bolt on? modding required? if you dont mind when doing your install of the motor and trans mounts/etc take a good pic. i havent seen a decent one yet utilizing this kit. also those wiring specialties pre-made harness's are going to be superb.

 

man, that manifold looks way sketchy.
cant just use the stock one?

rest of it looks neat though.

 

when you use the SYKO engine kit you have to use the R33 crossmember which will bolt right up to S13/14 chassis, you just have to reloactate the PS cooler line by making one using a small Tranny cooler or PS cooler.

I plan on taking lots of install pics though too.

Yeah i cant wait till Yury finishes them.

ISIS is a pretty legit company, Its no GReddy but i trust it.
Also Ken @ Enjuku Backs it up, So if i got an issue I know hell take care of me.

 

i meant the exhaust manifold. obviously.

 

Sorry to say, but ISIS isn't legit. They sell cheap stuff. It isn't as bad as Ebay, but I wouldn't trust them. Just sayin...

 

^ (has never used a single isis part and is probably basing an assumption off the bandwagon.) i like their rad's and intercoolers, but tim is right the weld/clearence on that Exhaust manifold looks scary. id wrap that sombitch alot with some thermal exhaust tape or whatever its called. worst case scenario , it cracks, oh no's! just re-weld it after. and is that syko elbow compatible with that manifold setup? i dunno if the placement of the turbo is moved slightly or not. good luck with your build

 

 

haha yeah I still got the stocker so i might go with it, still debating.

I do, Ive been dealing with Ken and Enjuku for a long time, Ken is a stand up guy, and unlike E-Bay crap, ISIS Actually does R&D with their Products.

I have their Control arm package on the S14 right now had it on there for like 6 months now i think, 0 Issues and very beefy design.


Obliviously.

well they sent me another Manifold that clears the V/C just the welds sucked on one area, but i cleaned them up
DO NOT BUY SHIT FROM XS-POWER THEY ARE WORTHLESS PIECES OF SHIT.
NO R&D GO INTO MAKING THESE MANIFOLDS


Well see, I planned on adding a brace for the turbo flange to help it from cracking, but if it does no biggie i got a welder.

well the manifold angled (not moved) the turbo out about an inch up on the block, and i know SYKO just did some revisements on the Elbow (not sure what they changed) but well see.
Thanks

 

The build is nice, but I have seen several RB's go into S14's. I wanna see more of that FD with the 20B in it. LOL. Keep up the good work man.